Tanner Pyrometers

Tanner Pyrometers

Operating Instructions:

Select the temperature scale
Readings are displayed in either Celsius or Fahrenheit. When the thermometer is turned on, it is set to the temperature scale that was in use when the unit was last turned off. To change the temperature scale press the °C or °F key.

Select the display resolution
The unit allows two choices of resolution:
High resolution: 0.1 °C or 0.1 °F (for measurements below 200°C or 200°F)
Low resolution: 1.0 °C or 1.0 °F
To select the display resolution, press the “1/0.1°” key.

Hold Mode
Press the “Hold” key to enter the data hold mode, and “Hold” is displayed on the screen. When the hold mode is selected, the thermometer holds the present reading and stops all further measurements. Pressing the “Hold” key again cancels the hold mode and allows further measurements to be taken.

Min/Max Mode
Press “Min/Max” once to begin recording Min and Max readings. Press “Min/Max” to select Min or Max.
Hold button down for 2 seconds to exit Min/Max function.

Offset Adjustment
The offset control is set at the factory to allow for the variations found in standard thermocouples.
By adjusting the Offset control you can optimize measurement accuracy for a particular thermocouple at a particular temperature.

Resetting the Offset Control
To return the control to the factory setting without having to recalibrate the unit:
Place the probe into an ice water bath and allow the readings to stabilize.
Slowly adjust the Offset control until the unit reads 0°C or 32°F.

Probe Detector
The red LED will be on when the probe is not inserted into the input of the meter and will turn off after the probe is inserted.
If the red LED stays on when the probe is attached, the probe is inoperative. (Replace Probe)